If you have experienced a flood and were unable to remove the water from your home within a timely manner, then you may notice mold forming inside your home. This mold should be tested by a professional or with a home kit to make sure it is not black mold. You can purchase a test kit at your local home store. Make sure to buy an immediate or five-minute kit so you can see the results right away. If the kit says that your home does not contain a harmful type of mold, then you can remove it on your own. However, you will need to keep mold from spreading throughout your home. Keep reading to learn about a few tips that can help you contain mold during the cleaning process.
Set Up A Barrier
Mold spores are extremely small and range in size from about 10 to 30 microns. For comparison, a grain of sand is between 100 and 2000 microns. This means that the smallest mold spores are about one-tenth of the size of a sand grain. Mold colonies will produce these spores and release them into the air in large amounts. Even an area that has a low concentration of mold spores will contain 6,500 spores per cubic meter. In a home where mold is growing, this number may be as high or higher than 50,000 spores per cubic meter.
If there is already a great deal of mold in your home, then you can release thousands of additional spores by trying to clean up the mold. If the spores travel to another damp area of your home, new colonies will form. The best way to reduce this problem is to set up a barrier in your work area that will prevent spores from traveling through your house.
Purchase a large roll of plastic film or barrier material at your local home store. You will want a film that blocks as many spores as possible, and high density polyethylene material is a good choice. Thick sheeting will work well, so look for a product that is at least several mils thick. You will want to secure the film around the entire work area, so measure long lengths of the material and attach it to the walls and ceiling with duct tape. Use the tape to seal the seams as well. To create a door, overlap two plastic sheets. Use a small piece of tape to keep the opening closed and release the tape when you need to enter and exit the space.
Secure A Fan And Create Negative Pressure
You will stir up mold spores as you work, and many of these spores will float through the air before they land on a surface. While your plastic sheeting will collect many of these spores, you will want the mold to leave your home instead of collecting inside of it. A good way to move the mold spores outside is to create a negative pressure atmosphere in your work area by placing an exhaust fan in an open window. You can place a regular window fan in the space or you can purchase a portable exhaust fan.
If your space is an interior area that does not have a window, then you can still use an exhaust fan. However, you will need to purchase a fan with an extension arm or a long duct. Run the arm or duct through the doorway of the room and out through the closest window. To make sure the fan works properly, use duct tape to attach your plastic sheeting around the exterior of the fan where the fan meets your barrier.
If you have too much mold to deal with on your own, contact a company like Servpro Of Bear New Castle.Share
6 September 2016
When you are in the middle of trying to renovate your space, you might be tempted to remove that dated crown molding or trash those antique faucets. After all, since you want your space to look new and minimalistic, who needs that hand-carved ceiling panel or that ornate archway? Unfortunately, if you make the wrong choices, you might end up throwing away valuable or irreplaceable materials. To help you to avoid this mistake, my blog is filled with ideas for how to fix up your home or business without damaging remaining artifacts. By protecting the natural design, you might be able to create a unique space that you will treasure forever.